Vantage
English Request a quote

Stainless valve bodies for a hydrogen compressor

316L valve bodies with a hydrogen-tight seat, turned and milled in one cycle to keep the bore and the seal face concentric.

Stainless valve bodies for a hydrogen compressor

The seat face and the bore have to be concentric within 0.0005 in, and any mismatch shows up as a leak at test pressure. Two operations on separate machines stacked the error past the limit.

A mill-turn cycle finished both features in one clamping, with a dedicated leak fixture on the bench next to the machine. The first 20 parts were tested to 1.5× working pressure before the run was released.

What the run looked like

  • Mill-turn cycle for concentric bore and seat
  • Dedicated leak test fixture built in house
  • Material certificates kept with each lot
  • Batch traceability from bar to box

Send a drawing. Get a quote in 48 hours.

STEP, IGES, PDF or DXF with quantities and finish notes. An engineer reads every request, and the reply comes with assumptions and lead time spelled out.

Prefer to talk first?

Request a quote

(815) 555-0142